RADVision SCOPIA 400 Betriebsanweisung PDF herunterladen (Seite 100)

90 SCOPIA 400/1000 Gateway User Guide

Configuring Gateway Settings

 In the IP Address field, enter or edit the peer IP address.

Note Two peers cannot have the same IP address or host name/Uniform

Resource Locator (URL).

 In the IP Port field, enter or edit the peer IP port number.

 In the Description field, enter or edit the description of the peer.

 Click Upload.

Note You cannot add a single peer to the Peer list section more than once.

To delete a peer device, select the peer device and click Delete. Deleting

a peer does not cause its active calls to disconnect, but no new calls are

routed to the deleted peer.

Note The peer hunting process stops when one of the peer devices accepts

the call or when the call is rejected with a disconnect reason. When a Gateway

has scanned the Peer list section and still cannot connect a call, the following

rules apply: if at least one of the peers rejected the call due to capacity

overload, the call rejection reason (towards the call originator) is “No

Resources”; in all other cases, the call rejection reason is “Unreachable

Destination.”

7 In the Peer hunting timeout (sec) field, enter the length of time (between

1 and 10 seconds) for which the Gateway waits for a Transmission

Control Protocol (TCP) response from each peer device contacted. The

default value is 5 seconds.

8 Select the Accept calls from defined peers only check box if you want

the Gateway to reject incoming calls from IP-side entities not defined in

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 207 208

Keine Kommentare

RADVision SCOPIA 400 Betriebsanweisung Seite 100