RADVision Scopia XT5000 Series Installationsanleitung PDF herunterladen (Seite 126)

Field Name Description

Rate K (ISDN) Sets the maximum call rate that the system uses for all

incoming or outgoing calls in ISDN connectivity.

Local audio-video (MCU) If using the system as an endpoint that can also host

conferences on the embedded MCU, select Yes to include

local video and audio in videoconferences.

Select No to hide the local audio and video and use the

system as an MCU.

6. From the web interface only, select Save.

7. Access the IP settings as follows:

•

From the web interface, select Administrator Settings > Calls > Preferences > IP.

•

From the endpoint interface, select Configure > Advanced > Calls > Preferences >

IP.

Figure 75: Configuring the IP settings from the web interface

8. Set the fields as described in Table 34: Configuring the IP-related call settings on page 126.

Table 34: Configuring the IP-related call settings

Field Name Description

DTMF RFC2833 (H.323) DTMF describes a method to send DTMF inside

an audio stream. This method is normally used in

SIP protocol but is uncommon in H.323.

If set to Yes, the H.323 application in the XT

Codec Unit can use DTMF transmission. Verify the

remote endpoint supports RFC2833 before

enabling this field.

RTP Firewall If set to Yes, the XT Codec Unit checks the source

of the RTP packets (audio, video, and

presentation) it receives to verify that it matches

the remote endpoint's IP address.

Installation Guide for Scopia XT5000 Endpoint with Embedded

Server for IP Office Version 3.2

Initial Configuration | 126

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 158 159

Keine Kommentare

RADVision Scopia XT5000 Series Installationsanleitung Seite 126