RADVision SCOPIA XT4000 Series Installationsanleitung PDF herunterladen (Seite 38)

Configuring Network Settings

This page allows you to setup the GLAN1 settings and the IP address the system uses for

placing a call.

Consult with your network administrator to configure these fields.

Before you begin

This procedure is performed as part of the basic configuration after “Adjusting the Image

Position” on page 31.

Procedure

Step 1

Press

and scroll to Yes from the Automatic IP address list.

Figure 5-5 Defining IP Settings

Step 2

Configure the IP addresses.

Step 3

Press Close to exit the quick setup wizard.

Configuring Gatekeeper Settings

If your SCOPIA XT Series works in conjunction with a gatekeeper, configure gatekeeper-related

settings. Use this section to configure gatekeeper settings.

This procedure completes the basic system configuration.

RADVISION | Installation Guide for SCOPIA XT4000 Series Version 3.0 Initial Configuration | 33

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 90 91

Keine Kommentare

RADVision SCOPIA XT4000 Series Installationsanleitung Seite 38