RADVision Scopia XT1000 Bedienungsanleitung PDF herunterladen (Seite 3)

RADVISION | Release Notes SCOPIA XT1000 | 3

640 x 480 @ 60, 67, 72, 75, 85 fps: VGA

• PC content encoding formats

same as DVI input formats @ 30fps

• HDMI output formats

1920 x 1080 @ 50, 60fps interlaced (for compatibility with some monitors)

1920 x 1080 @ 25, 30fps

1280 x 720 @ 25, 30, 50, 60fps

iVIEW/NMS support

iVIEW/NMS integration allows remote monitoring, configuring, upgrading and control

features of SCOPIA XT1000 endpoints, using SNMP and an AT command-based protocol on

TCP/IP. In particular, the following features have been introduced.

• Monitoring: NMS can request to endpoint identification and access capabilities.

• Status traps: NMS is able to detect if the endpoint is turned on, and its call status.

• Configuration and control: NMS is able to reboot the system, dial another endpoint and

configure general settings, H323 settings, SIP settings, Alert settings, Network settings,

and Video settings.

• Mass configuration: it is possible to replicate the configuration from one XT1000 to

several others. The full configuration is replicated, thus also the configuration of

peripherals, such as monitors and cameras, and therefore should be used with caution.

• Mass firmware upgrade

• Agenda synchronization.

NOTE: when XT1000 is under iVIEW control, some parameters are fixed by the remote

management system, as Gatekeeper IP address and LDAP server address.

NOTE: when XT1000 is connected to an iView LDAP server, it is able to retrieve only a limited

number of contacts (300)

ISDN Peer to Peer

1 2 3 4 5 6 7 8 ... 15 16

Keine Kommentare

RADVision Scopia XT1000 Bedienungsanleitung Seite 3